2K Epoxy Primer Filler

ColorMatic 2K Epoxy Primer Filler is universally applicable to all metallic surfaces such as steel, galvanized steel and aluminium.

  • beige | black
  • 200 ML

Characteristics

  • Excellent adhesion and corrosion protection for steel, galvanized steel and aluminium as well very good adhesion to magnesium
  • Adheres well to fibreglass
  • Once dry, overcoat with polyester products (spatula)
  • Long pot life and fast drying time
  • Very good flow, wet-on-wet application possible
  • Easy to sand - wet or dry
  • Solvent resistant and good insulation against moisture
  • Convenient 200 ml can to avoid leftover
  • Simple, time-saving application
  • Free of isocyanate and can be painted with all ColorMatic pre-fill water-based paints and solvents, 1K and 2K topcoats

Technical Data Sheet

Safety data sheet(s)

Usage instructions

Before use, carefully read and follow the instructions on the packaging.

  1. Shake can well until the audible noise of the mixing balls. Remove the protection cap from the bottom of the can and pull the pin out fully with the help of the inserted ring. This will release the knife, which will penetrate the wall of the aluminium cartridge
  2. The cartridge will then rotate 360 °, be completely open and release the hardener
  3. Shake the can to mix the A components with the hardener in the proper, predetermined ratio
  4. Shake the can well for 2 minutes
  5. Carry out test spray
  6. Clean surface with ColorMatic Silicone Remover (Art. No. 174469). After cleaning sand surface
  7. When use as a Primer: spray one coat about 15 - 20µ. When use as a Filler: Spray two coats about 50-60µ. 5 minutes drying time between coats
  8. Dry (20 °C) 8 hours or 25 minutes (60 °C) object temperature
  9. Wet-on-wet recoating possible after 20 minutes drying time
  10. The surface has to be sanded and recoated after 7 days

Choose your language