2K Hi-Speed Primer Filler

ColorMatic 2K Hi-Speed Primer Filler is universally applicable to all metallic surfaces such as steel, galvanized steel and aluminium.

  • grey
  • 200 ML | 500 ML

Characteristics

  • Filler and primer at the same time
  • Long pot life
  • Very fast drying time
  • Very good flow
  • Universal applicable for polished old paintwork and metal surfaces
  • Best to use 200 ml can to avoid surplus
  • Simple, time-saving application
  • Good adhesion to bare steel, galvanized steel and aluminium as well very good adhesion to magnesium
  • Recoat with ColorMatic pre-fill based paints, acrylic RAL

Technical Data Sheet

Safety data sheet(s)

Usage instructions

Before use, carefully read and follow the instructions on the packaging.

  1. Shake can well until the audible noise of the mixing balls. Remove the protection cap from the bottom of the can and pull the pin out fully with the help of the inserted ring. This will release the knife, which will penetrate the wall of the aluminium cartridge
  2. The cartridge will then rotate 360 °, be completely open and release the hardener
  3. Shake the can to mix the A components with the hardener in the proper, predetermined ratio
  4. Shake the can well for 2 minutes
  5. Carry out test spray
  6. Clean surface with ColorMatic Silicone Remover (Art. No. 174469)
  7. Old paintwork has to be cleaned and sanded
  8. Spray 2 - 3 coats (40 to 50µ)
  9. Leave to dry for approximately three minutes between coats
  10. Ready to sand after about 45 min (20 °C) or 30 min (60 °C). Ready to recoat wet-on-wet after 20 minute drying time

Choose your language